Knowledge of pulleys
-

2026-10-16Fleet Angle Checks for Wire Rope Hoists
Fleet angle describes the rope approach to a sheave. Learn what to record at both drum travel extremes, how to spot side contact, and what to share when sourcing a replacement sheave. -

2026-10-09Crane Hook Block Rope Guard Inspection
Rope guards help keep wire rope aligned with the sheaves of a crane hook block. Learn what to inspect after impact or maintenance, and what information to provide when a guard needs replacement. -

2026-10-07Crane Hook and Sheave Storage Before Installation
A crane hook or sheave may spend weeks in transit or storage before installation. During that time, a damaged bore, corroded contact surface or missing identification record can delay assembly. A rece -

2026-9-29Why Sheave Pin and Bearing Play Matters in Hook Blocks
A Sheave Must Rotate Freely and Stay Controlled In a crane hook block, each sheave rotates around a pin or shaft while carrying the moving wire rope. Smooth rotation is important, but rotation alone i -

2026-9-25What to Measure Before Replacing a Crane Hook Block
A Replacement Block Must Match the Existing Lift A crane hook block is not selected by lifting capacity alone. It connects the hook, sheaves, pins, bearings, rope path and lower-frame geometry into on -

2026-9-21How Sheave Groove Wear Shortens Wire Rope Life
The Rope and the Groove Wear Together Wire rope condition is often checked during crane maintenance, but the sheave groove deserves the same attention. A rope runs through the same contact area repeat -

2026-9-05Crane Sheave Replacement: Key Dimensions to Check
A replacement crane sheave must fit both the wire rope and the surrounding assembly. Two wheels with the same outside diameter can have different grooves, bearing arrangements and hub offsets. These d -

2026-9-03When Should an Electric Hoist Load Chain Be Replaced?
The load chain is one of the most heavily stressed parts of an electric chain hoist. Every lifting cycle creates contact between the chain links and the load wheel, gradually changing the link surface -

2026-8-26Single-Sheave vs Multi-Sheave Crane Hook Blocks
The number of sheaves in a crane hook block affects rope tension, lifting speed, block weight, headroom and maintenance requirements. Selecting a block only by rated capacity may result in an unsuitab -

2026-8-24How Sheave Wear Affects Crane Hook Blocks
A crane hook block depends on more than the strength of its forged hook. The sheave grooves, bearings, shafts, side plates and wire rope must remain correctly matched and aligned. Wear in any one of t -

2026-8-17How to Match Crane Sheave Grooves to Wire Rope
How to Match Crane Sheave Grooves to Wire Rope The contact between a crane sheave and its wire rope has a major influence on rope life, lifting efficiency and operational reliability. Even when both c -

2026-8-05How to Specify an Offshore Forged Pulley
How to Specify an Offshore Forged Pulley Offshore cranes and drilling equipment operate under dynamic loads, salt spray, humidity and continuous vibration. A pulley that performs reliably in an indoor


